iseg NHS Series, Руководство программиста

Страница: 38 / 61

Command Description
: CONF igure
:GPIB Configures the GPIB settings for devices with GPIB interface.
:ADDR ess ? Query the configured GPIB address.
Example: :CONF:GPIB:ADDRESS? 15
→
:ADDR ess ˽ { 1…30 } 1) Set a new GPIB address in the range 1 to 30.
Example: :CONF:GPIB:ADDR
˽ 16
:SERIAL
:BAUD rate? Query the devices serial baud rate.
Example: :CONF:SERIAL:BAUD? 9600
→
:ECHO? Query the serial echo state on (1) or off (0).
Example: :CONF:SERIAL:ECHO? 1
→
:ECHO ˽ { 0 | 1 } Enables (1) or disables (0) the serial echo.
Note: disabling the echo is
not recommended and without
support.
Example: :CONF:SERIAL:ECHO
˽ 1
:CAN
:ADDR ess ? Query the devices CAN bus address.
Example: :CONF:CAN:ADDR? 1
→
:ADDR ess ˽ { 0...63 } 1) Set the devices CAN bus address.
Example: :CONF:CAN:ADDR
˽ 5
:BIT rate ? 1) Query the devices CAN bus address.
Example: :CONF:CAN:BIT? 250000
→
:BIT rate ˽ { 125000 | 250000 }
1)
Set the devices CAN bus bitrate.
Example: :CONF:CAN:BIT 250000
˽
:INTER face
˽ LOCAL 1) Turns off the high voltage and switches from digital interface
operation to local operation. For devices without front panel
controls, the device switches to analog interface (AIO).
Example: :CONF:INTERFACE LOCAL
˽
:MODE?
1)
Returns 0 (default) if all interface commands turn the device into
remote mode, or 1 if only set commands turn it to remote mode.
Mode 1 is called “Listen Only” mode, as it allows to control the
device by front panel or AIO and still monitor the measured values
by SCPI.
Example: :CONF:INTERFACE:MODE? 1
→
: MODE ˽ { 0 | 1 } 1) If set to mode 0, all SCPI commands turn the device into remote
operation, in mode 1 (“Listen Only”) it only turns to remote
operation after receiving a set command.
Example: :CONF:INTERFACE:MODE
˽ 1
:LIST? Query the available interfaces in the device.
Example: :CONF:INTERFACE:LIST? CAN,USB,AIO
→
SCPI protocol common instruction set | Last changed on: 2020-10-07 |
www.iseg-hv.com
38/61