Isee IGEP ORION, Справочник по аппаратуре

Страница: 21 / 38

IGEP
TM
RADAR SENSOR ORION Hardware Reference Manual
ISEE 2007
S.L. All rights reserved, IGEP™ is a registered trademark from ISEE 2007 S.L. The following is provided for informational purposes only.
DOCUMENT FROM ISEE 2007 S.L. Ref: MAN-PR-RADR0010-RA1-001
21

LEVEL: IS THE NOMINAL VOLTAGE LEVEL

MODE 0: IS THE MODE 0 function pin name of OMAP microcontroller

MAX: IS THE ABSOLUTE MAXIMUM ALLOWED VOLTAGE LEVEL ON THIS PIN
(PERMANENT DAMAGE IF HIGHER VOLTAGE)

FUNCTION: DESCRIPTION OF PIN SIGNAL
o
(1): ISEE INTERNAL USE TEST PIN. AVAILABLE ONLY ON DEMAND
o
(2): INPUT when power supply is applied to radar board. OUTPUT
in other case.
For additional details on digital pins, please refer to section 2.4 and 2.5 of the “OMAP3530/25
Applications Processor” (version “SPRS507F–FEBRUARY 2008–REVISED OCTOBER 2009” from
website www.TI.com )
6.1.1 EXPANSION-I: JC1 INTERFACE
CONNECTOR JC1 is the basic interface of the Radar. IMPORTANT: Most of the signals are only
available on demand. JC1 is SAMTEC P/N: SSM-107-L-DV (2,54mm pitch).
PIN NAME LEVEL MAX FUNCTION
1
PW
3V3 +3,3V +3,5V +3V3 VOLTAGE OUT
(1)
2
PW
5VPW +5V +5,2V RADAR POWER SUPPLY IN
3
PW
7V +7V +7V ALTERNATIVE POWER SUPPLY IN
(1)
4
DIG3
SYNC
(L)
+3,3V +3,5V SYNC1 DDS SIGNAL OUT
(1)
5
DIG5
5VCTL1
(H)
+5V +5,3V CONTROL IF NW IN
(1)
6
DIG3
DIV +3,3V +3,5V VCO DIVIDED FREQUENCY OUT
(1)
7
DIG5
5VCTL2
(H)
+5V +5,3V CONTROL DOPPLER FILTER IN
(1)
8
DIG5
5VPULSE
(H)
+5V +5,3V PULSED MODE CONTROL IN
(1)
9
ANA
V
T
0 to 6V +6V VCO TUNING SIGNAL IN
(1)
10
NC
NC - - NO CONNECTION
(1)
11
ANA
IF +5V +5,3V IF SIGNAL OUT
(1)
12
ANA
IF ADC +5V +5,3V IF SIGNAL AT ADC OUT
(1)
13
ANA
IF SB +5V +5,3V IF SIGNAL AT MIXER OUT
(1)
14
PW
GND 0V 0V GROUND SIGNAL
Table 19 : IGEP
™
RADAR SENSOR ORION JC1 (SAMTEC P/N: SSM-107-L-DV)
Function names marked with gray shading denote that are available only on demand.