IGEP
TM
RADAR SENSOR ORION Hardware Reference Manual
ISEE 2007
S.L. All rights reserved, IGEP™ is a registered trademark from ISEE 2007 S.L. The following is provided for informational purposes only.
DOCUMENT FROM ISEE 2007 S.L. Ref: MAN-PR-RADR0010-RA1-001
10
5
ON-BOARD INTERFACES
This section will guide you through the K-BAND RADAR interface connectors:
Figure 3:
IGEP
™
RADAR SENSOR ORION
CONNECTORS OVERVIEW
5.1
CONNECTOR’s OVERVIEW
JP1
: Source Power connector
JC5
: USB OTG Connector intended to be used only when IGEP
™
COM MODULE is connected
to control the radar.
JC1
: OPERATIONAL ONLY ON DEMAND. This connector is intended to be used for internal
manufacturing tests. It can operate the radar in basic mode. Only Pin2, +5Vdc operational.
JC3 & JC4
: Expansion connectors intended for use with IGEP
™
COM MODULE or any other
compatible processor board.
JC2
: Expansion connector specially intended for use with IGEP
™
v2 or any other compatible
processor board.
RF COAXIAL UFL CONNECTORS:
Can be used for educational or research purposes
JF1
to monitor IF Signal
JL1
to monitor VCO Signal
JD1
to monitor Modulator Generated Signal
JD2
to monitor Modulator Synchronism Signal
JP1
JC5
JC1
JC2
JC4
JC3
JL1
JD2
JD1
JF1