IRSAP FLECHE AIR 1322, Руководство пользователя

Страница: 60 / 104

EN
60
4. MAINTENANCE OPERATIONS
4.1 BATTERIES RUN DOWN
If your remote control breaks during operation or the batteries are run down, the blower will continue to
operate with the last function sent by the remote control. At the end of the set operation, if in the meantime the
batteries have not been changed or the remote control has not been reset, the blower will work for about 30 min.
in manual operation without the remote control.
If the batteries have run down, even after 30 minutes, when replacing them you must reset the following:
-
Time
-
Day
- Date
The other settings will remain in the memory.
4.2 DISCONNECTING THE BLOWER (RECEIVER) FROM THE REMOTE CONTROL
(TRANSMITTER)
To disconnect the blower from the remote control, hold down the START BUTTON on the blower for 5 sec
(Fig. 5) and let the leds blink until they go out. In this way the remote control will be disconnected from the blower,
which can now be operated by the panel.
4.3 CLEANING THE FILTER
The blower has a removable dust filter on suction which catches any impurities present in the air in the room.
When the filter is dirty, the accumulated dust may block operation of the blower. So check the cleanliness of the
filter periodically (at least once a month) since it depends on the environmental conditions in which the appliance
is working.
ATTENTION: Before taking any action to remove the filter, switch off the appliance using the switch on
the rear of the blower (Fig. 4).
To clean the filter, proceed as described below:
1. switch off the blower using the ON SWITCH located on the rear of the blower (Fig. 4);
2. pull the filter at the rear of the blower to right or left to extract it, as indicated in Fig. 26;
3. clean the filter with water and a soft brush;
4. leave it to dry;
5. insert the filter in the blower;