Ironwood SLR305, Руководство пользователя

Страница: 22 / 28

Ironwood SLR305 | User Manual 22
To order oil for the reduction gear box, call Stiles Machinery at 1-800-727-8780. The reduction gear box uses the following oil. Lubrication
points are indicated on the accompanying drawing.
Load Ambient Temp. Shell Oil Mobil Oil ISO VG
Mild
0~5ºC Omala 150 Mobil Gear 629 ISO VG
EP 150
5~40ºC Omala 320 Mobil Gear 632 ISO VG
EP 320
40~65ºC Omala 460 Mobil Gear 634 ISO VG
EP460
Additional lubrication points and lubrication frequency
Lubrication Points Methods Lubricants Frequency
1. Oil cups at arbor and both
ends of slot pieces
Fill oil Shell slide oil T08
(Sliway Tonna 08) Once daily
2. Elevation screw under bevel
gear box
Grease with brush Grease Once monthly
3. Flange bearing under
handwheel
Grease gun Shell grease R2
(Grease Alvania R2) Once per 2 weeks
4. Two grease nipples on the
arbor
Grease gun Grease Once monthly
5. Oil box of lubricator Fill oil Shell slide oil T08
(Sliway Tonna 08) Fill oil when alarm sounds
6. Flange bearing of chain
wheel
Grease gun Shell grease R2
(Grease Alvania R2) Once per 2 weeks
7. Screw near the arbor Grease with brush Grease Once daily
8. Oil box of gear reducer Fill oil Shell Omala 320 Once monthly
8.3 Inspection
Feature Interval/Situation
Saw blade Daily
Belts Every 200 hours of use
Emergency stop Daily: by functional test
Anti-kickback fingers Daily
Electrical cabinet/system Monthly: check for loose wiring
terminals loose and insulation
deterioration; vacuum electrical
cabinet
8.4 Clean Roller Housing
Every week, raise and lower the roller housing several times to
prevent sawdust accumulation on the screw and nut. This helps
maintain smooth movement of the roller housing and prevent
damage to the screw and nut.
8.5 Tighten Saw Arbor Motor Belt
To maintain optimum operation, the saw arbor motor belt should
be periodically tightened. A new belt should be checked for tension
weekly for the first 3 months. From then on, the belt should be
inspected and adjusted every 200 working hours.
To adjust the V-belt tension:
1. Disconnect the machine from power and tag out.
2. Open the side access door.
3. Loosen the v-belt tension adjustment screws 1 and 2 on the
motor base.
4. Adjust the tension until the v-belt is tight.
5. Tighten adjustment screws.
6. Close access door.
Motor base collar
Adjustment screw
Rear cover