Ironwood FX 750 | User Manual
9
3.7 Pre-Operation Cleaning
WaRninG
Use proper cleaning agents and methods described below. Do not
use gasoline or other petroleum-based solvents. Risk of fire
or explosion.
Machine Tabletop Surface
Remove and discard the protective paper from the top of the
machine. Use a soft cloth and nonflammable degreasing agent, such
as Simple Green or other citrus-based cleaners to carefully clean off
all grease. Do not use abrasive pads.
Table Rings
Spindles are fitted with up to four table rings for a wide variety of
tooling configurations. Table rings may be inserted or removed
individually. Remove and clean the rings, starting with the
innermost ring.
Be aware that the rings fit tightly. To remove a ring, place fingers
inside ring and position on opposite sides. Gently rock the ring
back and forth to release the pin. Remove all rings and clean with
degreasing agent.
Caution
Threads on the spindle and spindle shaft are very sharp. Use care
when cleaning to prevent injury.
With all rings removed, thoroughly clean the taper of the spindle and
the internal taper of the spindle shaft.
To replace the rings, start with the outer ring. Align the locator pin
on the bottom of the ring with the insert on the outer rim. Repeat for
each ring.
Table rings are
supplied with
the machine.
Outer ring with
locator pin.
