Ironwood FX 750, Руководство пользователя

Страница: 13 / 24

Ironwood FX 750 | User Manual 13
4.4 Top Dust Cover
PARTS REQUIRED:
• Dust cover assembly
TOOLS REQUIRED:
• Allen wrench
Assemble the top dust cover to the top of fence body using the
two locking knobs and washers included in your attachment
hardware pack.
WaRninG
Do not operate the machine without the dust cover attached.
The top
dust cover
attaches
to the
fence body.
4.5 Safety Guard Assembly
WaRninG
Always use the safety guard assembly and hold-down when
operating the FX 750. Select and adjust the safety guard to the
tooling currently being used.
PARTS REQUIRED:
• Safety guard assembly
TOOLS REQUIRED:
• Allen wrenches
1. Attach the guard base to
the fence assembly body at
the pilot hole locations using
screws provided.
2. Attach a bracket to the
vertical bar in the base,
with the bracket facing
the operator. Loosely
attach the bar using an
Allen wrench and set screw.
3. Loosely install a horizontal bar on the bracket. Loosely attach
a bracket at the other end, with the bracket facing up. Loosely
install the other horizontal bar so it extends toward the operator,
beyond the fence. Attach two brackets with hand screws at the
other end of the horizontal bar.
4. Attach the orange hold-down to the end of the inner vertical bar.
5. Attach the clear plastic safety guard to the outer vertical bar
using set screws.
Always use
the safety
guard assembly.
The safety guard
is installed on the
fence assembly.
6. Once the safety guard assembly is configured as shown, tighten
all set screws.
The safety guard hold-down assembly can be angled up out of the
way using the adjustment lever.
4.6 Miter Gauge Assembly and Clamp
Use a miter gauge to make small or angled cuts.
PARTS REQUIRED:
• Miter gauge assembly
TOOLS REQUIRED:
• None
Mitre gauge
assembly.
Mitre gauge
bar.
1. Angle the hold-down and safety guard up out of the way.
2. Locate the miter gauge bar and insert the bearing of the bar
into the T-slot of the machine table.
3. Place the miter gauge on the bar, with the stud of the bar
protruding up through the opening in the miter gauge body.
4. Fasten in place using washer and locking knob.
Stop Bar
1. Insert the stop bar into the hole on the side of miter gauge
body, and lock into place with locking knobs.
2. Assemble the stop to the stop bar as shown in image above,
and tighten the locking knob.
Clamp
A clamp is supplied with your miter gauge to securely hold
workpieces. The clamp can be moved up or down as required.