5.5 Optional Coulter Kit
IMtall
the optional
ooulter
in
heavy trash or ground
cover conditions. This 'hill cut through the surfaoe
material and make a dear path for the moldboard.
1. Stand the plow uprigh.t and block the frame securely
to support the plo
w
and keep
it
from mo'Wlg.
2. Install the U-bolt through the bracket end plow
beam. Slide the ooulter stem up from the bo«om
through
the
U�bolt.
3. Install the
k>ck
nuts. Snug
the
nuts enough to keep
the ooutter stem from dropping.
4.
Move the ooulter to the desired position and tighten
the nuis.
5. Remove the. blocks or safety
s
t
ands
.
IronCra
ft
(
423)-405-5150
21
5.5. t Coulter Ad}ustment
Adjvst the ooulter laterally
by
loosening the U-bolt and
twisting the ooulter shaft. For average conditions. set
the coulter blade between 1/2� and
5/s-
to the left of the
landslide. Adjust the height of the couller by raising or
lowering the ooulter shaft. The coutter should be set
deep enough to cut trash and le.ave a clean furrow
wait
If
set too deep.
it will
push
trash
i�tead
of
cutting
it
l.n hard soils, raise the ooulter to reduce the tendency
to lift the plow out of the ground. In sofler sols,
especialy when there is heavy trash, move the ooutte.r
down. Be sure to tighten the U--bolt nuts after adjusting
the. ooulter.
5.6 Optional Gaugo Wheel Kit
1. Stand the plow upright end block the frame securely
to support the plow end keep it from moving.
2. loosely bolt the gauge wheel adjuster bracket to
the beam ahe.sd of the plow share end ooulter. if
equipped.
3. Slide. the depth gauge bar up from the bottom
through the adjuster bracket end tighten the. nuts.
4. Remove the blocks or safety stands.
5.6. 1
Gaugo
Wllffl
Adjustmont
Adjust the gauge. whee.I by loosening the nuts and
sliding the depth gauge bar through the. adjuster
bracket. Atways re•adjust the gauge wheel after
changi"lg the plcw.·ing depth. The wheel shoukt not
car,y too much of the. weight.
6000 sell!, Molllboartl PIO',t,'i
