Vertiq 2306
*
Now to connect the software serial resources, type:
resource Serial_TX 11
B00
resource Serial_RX 11 A10
Tip: the red-colored text above indicates that particular value will change for each motor. So for
motor 2, you would type:
resource motor 2 none
and
resource Serial_TX 11 B01
. The other two
commands remain the same.
–
Save your settings by typing:
save
–
Your flight controller will restart. If the GUI doesn’t disconnect automatically, press “Disconnect”
Enable Software Serial (use above image for reference)
–
Click the “Connect” button again
–
Click Configuration tab in the menu on the left
–
Scroll down to Other Features and enable SOFTSERIAL
–
Click Save and Reboot in the bottom right corner
–
Your flight controller will restart. If the GUI doesn’t disconnect automatically, press “Disconnect”
Make the FC a Passthrough Device
–
Click the “Connect” button again
–
Select the CLI tab in the menu on the left
Tip: for future use you can save this configuration to easily talk to your motors. Use the
diff
command
now by mimicking the steps in the “Making a backup” section so you can make this process easier the
next time. Use the steps in “Restore your FC” to setup the softserial. Make sure you use a different
filename for your backup file!
8
CONNECT COMPUTER VIA BETAFLIGHT
V1.1
©
2021 IQinetics Technologies Inc.
