iQTS244
Operator’s Manual
888-274-7744
www.iqpowertools.com
En
gli
sh
, E
N
STARTING AND STOPPING
Before starting
Wear personal protective equipment. See instructions
under the heading ”Personal protective equipment”.
Make sure no unauthorised persons are in the working
area, otherwise there is a risk of serious personal injury.
Prevent unintentional starting of the motor. Ensure the
power switch is in the OFF- position before connecting
the machine to a power source.
Check that the machine is assembled correctly and do
not show any signs of damage. See instructions in the
section “Assembling and adjustments”.
• Perform daily maintenance. See instructions
in the section “Maintenance”.
STARTING MACHINE
The saw power switch starts the saw motor and vacuum
motor simultaneously. To start the saw motor press
the
POWER
switch
-
or on symbol. Defective switches
should be replaced by an authorized service workshop.
STOPPING MACHINE
To stop the saw motor press the
POWER
switch
O
or off symbol.
LASER SWITCH
This tile saw is equipped with a laser light guide for lining
up cuts. To turn on the laser light guide press the
LASER
switch
-
or on symbol. To turn off the laser light guide
press the
LASER
switch
O
or off symbol.
WARNING!
PLEASE READ THE OPERATOR’S
MANUAL CAREFULLY AND MAKE
SURE YOU UNDERSTAND THE INSTRUCTIONS BEFORE
USING THE MACHINE
WARNING!
MAKE SURE CUTTING BLADE
COMES TO A COMPLETE
STOP BEFORE PERFORMING ANY MAINTENANCE OR
TRANSPORTING.
Transport and storage
GENERAL
Stop the motor and disconnect the power cable before
lifting or moving the machine.
• Secure the equipment during transportation
in order to avoid transport damage and
accidents.
• Ensure that the rolling table is locked
and that the extension table is locked in
its inner position.
• Store the equipment in a lockable area
so that it is out of reach of children and
unauthorized persons.
• For transport and storage of Blades, see
the section “Blades”.
• Lift the machine at the short ends.
TRANSPORTING
WARNING!
BE SURE TO LOCK
THE ROLLING TABLE
AND CUTTING HEAD
BEFORE MOVING OR
TRANSPORTING TO AVOID
EQUIPMENT DAMAGE OR
PERSONAL INJURY.
Raise the transport handle
by pulling transport handle
lock pin (A) then pulling up
n transport handle (B).
Machine can now be tipped
forward onto the wheels for
easy transport.
TRANSPORT INSTRUCTIONS
Make sure the table lock is secure before transporting saw. Failure to lock
table may cause the table to slide off the saw and cause serious injury.
1. Turn machine OFF. Unplug and secure power cord.
2. Lock cutting head in a down position.
3. Lock rolling table to avoid injury during transport.
4. Unlock transport handle and extend for easy transport.
8.1
LASER RADIATION DO
NOT STARE INTO BEAM,
CLASS 1M PRODUCT
A
B
