SECTION THREE
FLOODLIGHT TRANSMITTER:- INSTALLATION
After choosing a suitable location (see previous section) install the unit as follows:
The unit is suitable for connection to a 240V 50Hz electricity supply. It is suggested that
3-core round flexible cable of 1mm² gauge is used. An internal switch should be installed to
switch the power to the unit ON & OFF. This allows the sensor to be easily switched off when not
required or for maintenance purposes.
Unfasten the screw on the top of the floodlight. Install the halogen bulb, making sure not to touch
the bulb with bare hands. It is suggested that the bulb is handled using a dry cloth.
Ensure the bulb is correctly fitted in the lampholder before use.
Re-attach the floodlight front cover, do not overtighten the fixing screw.
This unit uses an integral wall fixing plate, detach the wall fixing plate by unscrewing the fixing
screw on underside of the wall plate (diagram E).
The floodlight is located onto the wall plate by a lug which is inserted into the rectangular recess
in the top of the wallplate. To remove, slide out the floodlight from the bottom edge (1) and lift
upwards (2), the lug will lift out of the recess and seperate from the wall plate. See diagram F
Mark the position of the fixing holes. Ensure wall plate is correctly positioned. (diagram G). Note
“TOP” engraving on inside of wall plate.
Drill the holes. Insert wallplugs into the holes.
PIERCE & PASS THE CABLE THROUGH THE GROMMET BEFORE SECURING WALL
PLATE TO WALL
.
It is recommended that the grommet is pierced with a screwdriver to ensure a better seal.
Fix the wall plate to the wall (diagram G)
This unit is supplied with a hanging attachment (tether) to aid installation.
If it is not required, simply remove from the unit and discard.
Ensure the tether is securely fixed into the slot before releasing the weight of the unit.
The unit can now be suspended below the wall bracket. (Fig H)
*** IMPORTANT ***
Switch off the electricity at the fuse box by removing the relevant fuse or switching off
the circuit breaker before proceeding with the installation.
CONNECTION
Connect the cable to the terminal block on the unit as follows (see connection diagram):
NEUTRAL (Blue)
N
EARTH (Green/Yellow)
LIVE (Brown)
L
Ensure that the connections are secure.
Fit the terminal block to the posts on the wall plate
Re-fit the floodlight to the wall plate by locating the lug onto into the recess on the top of the wall
bracket, carefully rotate the floodlight so it fits over the wall plate (reverse diagram F)
Fully tighten the fixing screw (fig E).
SF-PTV180-500-T.qxd 13/04/2005 13:51 Page 4
