SECTION FIVE
FLOODLIGHT TRANSMITTER
Detection Range
Detection Angle
Power Supply
Maximum Switchable Load
Lamp Type
Time On Adjustment
Dusk Level Adjustment
Environmental Protection
Transmission Range
Up to 12 metres
180º
230 V AC ~ 50Hz
2000W (4 x 500W Tungsten Halogen)
500W R7S Halogen Lamp
5 seconds - 12 minutes
Day & night or night only operation
IP44 (suitable for outdoor use)
Up to 100m (varies with surrounding structures)
TECHNICAL SPECIFICATION
If you experience problems refer to Troubleshooting Guide.
If problems still exist, do not immediately return the unit to store.
Telephone the IQ Customer Helpline
0871 71 71 100 Weekdays 9.00am - 5.00pm
[email protected] www.iq-group.com
Qualified Customer Support Co-ordinators will be on-line to assist in resolving your query.
Halogen Lamp Replacement
CAUTION
Always handle quartz halogen bulbs with a soft cloth. Do not touch the bulb with your bare hand,
as it will shorten the life of the bulb.
1. Switch off the floodlight. Do not touch the Floodlight while it is in use or still hot. Allow it to cool
(about 5 minutes) before touching it.
2. Replacement bulb type is 240V mains halogen 500W or 300W R7S cap floodlight bulb.
3. Isolate the mains supply and then unscrew cover screw on the top of the unit.
4. Open the glass cover. The cover is mounted on hinges and will swing open.
5. To remove existing bulb, depress then lift one end of the bulb to remove.
6. Install new bulb by inserting one end first and depressing gently until enough clearance is
gained to seat the other end in the socket. Rotate the bulb to ensure it is properly seated.
Warning!
In the event of the cover glass shattering, do not replace with normal household glass.
Do not operate without the glass shield in place. If the glass shield is cracked or damaged, it
must be replaced. If the glass is replaced, use only tempered glass of equal thickness
SF-PTV180-500-T.qxd 13/04/2005 13:51 Page 9
