IPG Interpack ET 2Plus H275, Руководство оператора и список запчастей

Страница: 21 / 78

21
R00
S
ET
-U
P
P
ROCEDURES
One Way Clutched Roller Adjustment
This one direction, tensionable roller
ensures that proper tension is present when
cutting the tape. It is preset at the factory.
Should re-adjustment be necessary, follow
these steps:
1. Decrease one way clutched roller
tension. If the tension is too high,
one may get shorter tape legs than
expected. The blade should cut, but
it may snap back at the rear of the
box. In this case the friction nut has
to be loosened. Typically do less
than an 1/8 turn at a time and test.
2. Gradually, apply a very small amount
of tension to the one way clutched
roller until a the tape is cleanly cut as
the case processes
3. Too much tension will cause the tape
to wrinkle or snap back
4. Too little tension will not cut the tape.
Figure 7-12
UUU
Main Spring Adjustment
The main spring tension is set at the factory.
This setting should be optimal for most
applications. Environments where a
different setting is desirable would be:
1. Void filled cases would need a lighter
wipe down pressure.
2. Overfilled cases might require additional
wipe down pressure.
3. Double wall corrugated might need
additional wipe down pressure to
overcome the memory of the major flaps.
4. Thinner walled corrugated cases might
require less wipe down pressure.
5. Faster line speeds would need additional
spring tension to provide a quicker wipe
down of the rear tape leg.
Should the need arise to increase or
decrease the wipe down pressure, follow
these steps:
1. Remove main spring (Item #1).
2. Loosen the flathead countersink screw
(Item # 2).
3. Relocate to move further away from
pivot axis point to increase torque,
closert to decrease torque.
Figure 7-13
Friction
Nut