ipf electronic DW34311 Series, Руководство пользователя

Страница: 12 / 18

page 12
manual pressure sensor
ipf electronic gmbh
Kalver Str. 25 - 27
58515 Lüdenscheid - Germany
www.ipf-electronic.com
Subject to alteration!
Tel +49 2351 9365-0
Fax +49 2351 9365-19
info@ipf-electronic.com
*a flashing point on the display indicates that a value can be changed.
After confirming the set value the displayed value will blink three times.
parameter list
SP1
switch-point S1
HYS1 / rP1
hysteresis S1 / release poosition S1
SP2
switch-point S2
HYS2 / rP2
hysteresis S2 / release position S2
EF
This menu item encloses a sub menu which contains further pa-
rameters.
Press the Enter/Set for at least 5sec to get access to these parame-
ters.
rES
Reset (getting back to the factory settings)
Press the Enter/Set button at least for 5sec to reset the system.
Thereafter the unit returns into the RUN Mode automatically.
programming
button display description
Enter
Set
Enter
Set
1X
SP1
Press the Enter/Set button briefly to get into the main menu.
Press the Enter/Set button again.
The current value for switch-point S1 will be displayed.*
Set the parameter value with the arrow keys.
Confirm the set value with the Enter/Set button.
1X
rP1 /
HYS1
Press the Enter/Set button.
The current value for the release position S1 respectively
the hysteresis will be displayed.*
Set the requested value with the arrow keys.
Confirm the value with the Enter/Set button.
1X
Output 2 is set as analog output: A.On
Output 2 is set as switching output SP2 / rP2 respectively
HYS2. Changes can be made as described above.
Output 2 gives an error signal: Er.On
As soon as the Outputs become inactive, EF will be dis-
played.
1X
EF
Press Enter/Set or briefly to get into the RUN Mode.
Press the Enter/Set button continuously for min. 5sec to get
into the advanced functions. A point is blinking in the display
as long as the button is pressed.
Changes inside the menu items can be made as described
above. The possible menu items can be seen in the pa-
rameter list.