iPECS eMG80
System DECT Installation Guide
Issue 1.3
25
3.6.3 User Subscription
This procedure is for subscribing the wireless terminal to iPECS eMG80 system.
To subscribe the wireless terminal to iPECS eMG80 system at Attendant Station:
1. From the Attendant station, press
[TRANS/PGM]
button.
2. Dial 0#.
3. Press the FLEX 1 button.
4. Enter the appropriate Station Number.
5. Enter the phone type ( 2=Standard GAP, 3=GDC-40x/45xH, 5=GDC-480H/500H)
6. Press the
[HOLD/SAVE]
button; a confirmation tone is heard.
7. The Attendant Station LCD should display “SUBSCRIBED: SUCCESS”; if message is
not received, perform Steps again from #1.
To subscribe at the wireless terminal (e.g. GDC-480H/500H):
1. Press
[MENU]
button.
2. Select
[Phone Register]
menu.
3. Select
[Subscription]
menu.
4. Select the empty base number (1-4) using
[UP/DOWN]
button, and press
[OK]
button.
5. The wireless terminal will search for the register system and ‘SEARCHING...X’ is
displayed on the LCD. After searching the register system, PARK value is displayed on
the LCD.
- If value displayed is correct, press
[OK]
button; confirmation tone will be heard and
displayed at the Attendant Station and at the wireless terminal which will then return to
an idle state displaying the appropriate station number.
- If value is not correct, press the
[NO]
button; the terminal will retry the search and
display ‘SEARCHING…X” on the LCD.
6. Enter AC code (up to 8 digits decimal representation) and press
[OK]
button.
7. If search fails, repeat the above steps at the Attendant Station and Wireless Terminal.
Condition
1. Wireless terminal must be subscribed to system for normal service.
2. Only Attendant can subscribe the wireless terminals (GAP).
3. Attendant can subscribe another wireless terminal after one subscribing procedure.
4. An error tone will be heard if attendant attempts to subscribe a wireless terminal that
was subscribed already.
