ipDatatel BAT-CDMA-WIFI, Руководство по установке

Страница: 8 / 32

6. When you connect to the above IP Address it will launch the
AP Configuration Tool.
7. Click on “Scan for Wireless Networks”. The list will
populate with all available wireless networks in your area.
8. Find the customers Wireless Network and select it. If security
credentials are required, you will be prompted to enter them.
9. You should now be connected to the customers Wi-Fi
Network.
Connecting to a Wireless Network (WPS)
Press the SW1 button (located on the top left side of the board) once,
it should trigger the device to enter into WPS mode. LED 6 will blink
as long as the device is in WPS mode. Follow the router’s directions
to turn WPS on. Typically, enabling WPS involves simply pressing a
button labeled ‘WPS’ on the customer’s router or switch. Once the
Wi-Fi device and the router recognize each other, LED 6 will go solid
indicating it has connected. You can now press the SW1 button twice to
indicate the signal strength of the device.
Reset the Wireless Network (AP Configuration Tool)
Locate the button labeled SW1 on the top left of the board. When this
button is pressed 3 times, it causes the device to perform a software
reset and will allow you to perform the ‘AP Configuration Tool’ again.
Dual-Path Alarm Communicator - Installation Guide ............................................... Page 8