5
Installing the DataSafe NAS
Iomega DataSafe NAS
2
Toggle the main power switch on the back panel to the “ON” position (
I
).
3
Press the soft power switch on the front panel (shown below), to turn on the unit.
Figure 2-3. Soft Power Switch, Front Panel
The LED in the power switch will come on. After a few moments it will begin blinking, and continue to
blink for several minutes during the power-up cycle. When the power light stops blinking and disk
activity stops, your DataSafe NAS is ready to configure.
Installing DataSafe Wizard Software
Use a workstation that is logged onto the network where the DataSafe NAS unit is connected. Insert
the DataSafe NAS Installation and Documentation CD into your CD-ROM drive. If the “Welcome to the
DataSafe NAS” screen does not appear, the auto-insert notification for the CD has been turned off. In
this case, use Windows Explorer to launch the setup program from the CD.
Click on DataSafe Wizard for Setup & Discovery to begin your installation.
DataSafe Wizard
When the Install DataSafe NAS Family
screen appears, click the Install DataSafe
Wizard button. The wizard will guide you
through the installation process.
If you have an older version of DataSafe
Wizard on your server, you will be notified
and asked if you want to un-install the older
version, before your newer version is
installed.
SOFT POWER SWITCH
(FRONT PANEL)
Содержание 1562
Страница 1: ......
