27
With Pliers or Vise Grips - good for fi eld use
Removing the Housing
1. With your free hand, grasp the sensor body. Press down to compress the square
ring. Twist gently. Once the body begins to twist, you can stop the compression
action.
2. Finish gently twisting until the sensor body is removed.
3. Carefully disconnect the wiring connector inside from the circuit board in the
top cap.
Cabled Sensor
1. Grasp the pliers on the swaged area
(do not grab the knurled diameter).
2. Find a hard edge and place the tips
or side of the jaws of the pliers onto
this edge as shown. This will allow
you to press down with your weight
to compress the square ring.
Continue to
Removing the Housing
below.
Cableless Sensor
1. Leave the cableless cap on in order
to protect the pins inside.
2. Grasp the pliers on the knurled
area tightly being careful to avoid
grabbing the knurled cap.
3. Find a hard surface and place the
cableless cap down onto it. This will
allow you to press down with your
weight to compress the square ring.
Continue to
Removing the Housing
below.
Cabled Sensor
Cableless Sensor
