ICT 700 signal field wire connector.
Use your thumb to push back and down hard on
the white tabs located on top of the signal field wire
connector. While holding down the tabs, put one
stripped end of the twisted wire into each of the open-
ings in the connector. Either end
of the wire may be put into either
opening. Hold the ends of the
wires in the openings and release
the tabs. The ends of the wires
will automat i c a l ly be cri m p e d
into the wire connector.
Note: You will have to
apply pressure
to push down the white tabs on the wire
connector; the connector will not
break, so do not be concerned about pushing
too hard.
To remove a wire from the wire connector, push
back and down on the tabs on the connector and pull
the ends of the wire out.
Connect the other ends of the short length of
twisted wire to the connector on the LP3000 circuit
board marked TRANSMITTER.
After you have connected the twisted wire
between the ICT 700 and the LP3000, connect the
ends of the twisted pair wire coming in from the sig-
nal field wire to the wire connector on the lower right
side of the LP3000 circuit board marked LOOP.
ICT 700, 12vAC Transformer,
Model 100-0020-01
To operate the ICT 700 system, plug the
t ra n s fo rmer into the power jack , J 1 , on the tra n s m i t-
t e r ’s circuit board. Then plug the t ra n s fo rmer into
a 110vAC electric outlet. Any customer with another
electric power source should ask their Invisible Fence
®
professional for an appropriate adapter.
Only use the model 100-0020-0l, 12vAC trans-
former provided with the ICT 700. This transformer
will supply the output necessary to power the ICT
700. Specifications:
INPUT: 120vAC 60 Hz 15W
OUTPUT: 12vAC 750mA
UL/CSA CLASS 2 Transformer
UL listed/CSA certified
Warning: The model
100-0020-01 is the
only transformer authorized
by Invisible Technologies, Inc. to
be used to supply the power to
an ICT 700. The use of an y
other transformer may result in
a malfunction of the transmitter
and the ICT 700 system.
Emergency battery backup power is not available
for the ICT 700.
Setting and Checking the Width of the Signal Field
The signal field is what activates your pet's
Computer Collar
®
receiver. The signal field can be set
to various distances from the signal field loop wire
depending on the layout and size of your property.
The distance from the loop wire to the edge of the sig-
nal field is the width of the signal field. The average
setting of the signal field is 6 to 10 feet(1.8 to 3.7m)
wide.
Caution: Always take the Computer
Collar off your pet first, before setting
the signal field, and then remove
the transmitter’s cover.
ICT 700 Installation continued
ICT 700 signal field wire connector
ICT 700 transmitter LP 3000
5
