I f, for any re a s o n , your Inv i s i ble Fe n c e
®
system does
not operate as described in this manu a l , or if yo u
encounter any difficulty training your pet, please call
your Inv i s i ble Fence pro fessional immediat e ly.
Computer Collar
®
Receivers continued
9
put it into the Power Cap battery tester the same way
that you would put it into a receiver. If the battery is
good, the green and red LEDs on the tester will both
light. If neither LED
on the tester lights,
or just the red LED
lights dimly, the bat-
tery needs to be
replaced.
Signal field wire is solid or stranded copper, insu-
lated wire, which carries a harmless radio signal.
There is no hazard in touching or exposing the wire
because the wire carries only low voltage electricity.
Some installations are unique. The following
measurements are guidelines for typical Invisible
Barrier
®
signal field wire installations.
• Dead or weak Power Cap
®
receiver battery
• Computer Collar
®
not adjusted
properly
• Break in signal field wire
• Signal field is too narrow
• Power not supplied to transmitter
or 110v power is out
• Pet needs additional training
• Break in signal field wire
• Signal field wire not connected
to transmitter or LP 3000
• Power surge to transmitter
• No power from 110v outlet
• Transformer plug is loose
or disconnected
• Power surge to transmitter
• Dead Power Cap
®
receiver
battery
• Signal field wire is disconnected
• Signal field is too narrow
• 7K-10K channel switch on
transmitter is not set to the
same frequency as the receiver
SYMPTOM
CAUSE
Pet getting out
LED not blinking,
beeping sound
LED not blinking,
no beeping sound
Green LED out
Computer Collar
Receiver
not working
Signal Field Wire Specifications
ICT 700
Protected Area
0 to 8 acres
8 to 12 acres
Feet of Loop W i r e
400 to 2500
2500 to 3000
Feet of Twisted Pa i r
up to 150
up to 150
Wire Size
AWG 14
AWG 12
Ja cket PE .045” (1.14mm )
Service Diagnostic Questions
