Invicta IPC-S, Инструкция по эксплуатации

Страница: 35 / 44

35
Anti-tip Devices
Height adjustable Anti-tip devices are supplied
as
standard with the Invicta Powered
Wheelchair.
For normal use, it is recommended that the Anti-
tip devices are set to the highest position, Fig.37.
This will give a ground clearance between the
jockey wheel and the floor of 40mm. In turn, this
will allow the wheelchair to be able to climb an
obstacle of up to 50mm.
To alter the Anti-tip height, pull the Spring-loaded
Locking Pin rearwards to disengage the Anti-tip
Stem. Re-set to required height and re-engage
Locking Pin.
Retaining Lap-Belt
The standard Lap Belt supplied with the Invicta
is the RMS PB002 with single “Pull
-
tight” plastic
buckle.
Separate the Belt at the main buckle by
depressing the locking tongue, Fig.438.
With the User seated, route each end of the Lap
Belt up and over the User’s hips and round to the
front of the User, connecting the main buckle in
the centre of their lap.
Adjustment is made by pulling the “free
-
end”
through the buckle to the required position.
Overall belt length can be adjusted at the Tri-slot
mountings located at each end of the Belt where
they are attached to the Seat frame.
NOTE: If it becomes necessary to change the
Backrest angle, it may also be necessary to re-position the Lap Belt Mountings,
utilising an alternative vacant hole on the Backrest Connecting Bracket. Fig.18
Fig.37
Spring-loaded
Locking Pin
Fig.38
Main Buckle
Locking Tongue
“Pull
-
tight”
free-end