Invicta IPC-S, Инструкция по эксплуатации, Страница: 18 / 44

18
Adjusting Tension-adjustable Backrest
No Tools are Required for this procedure.
Before commencing this procedure, the
wheelchair should be vacated and parked on
a firm level surface, with both Parking Brakes
applied and Drive Selector Lever set to the
“Drive” position, Fig.9.
Remove Headrest if applicable

Adjusting the Tension-adjustable Backrest
will require removal of the Velcro attached
Padding Cover Fig.12. This will expose the
upper and lower Adjustment Panels Fig.13

Each support strap can be adjusted
individually by releasing the Velcro contact
area, setting the strap to the length
required and re-connecting via the Velcro
areas.

Re-install the Backrest Padding Cover,
starting by attaching the narrow Sacral
Pad against the front of the Backrest as
Fig.12. Continue, by routing the Padded
panel, with motive Fig.14, upwards at the
rear of the Backrest towards the top.
Finally, folding the last panel over the top
of the Backrest and securing to the front of
the via the Velcro panels.
———————
Where the wheelchair is to be used with an
alternative contoured Backrest, the Tension-
adjustable Backrest will have to be removed.
If the original Backrest is to be discarded
once removed, then it can be cut off the
Backrest Frame after removing the two
retaining screws from the upper and lower
panels.
If the Tension-adjustable Backrest is to be
stored after removal, for re-use at a later
date, this will involve disconnecting the
Backrest Frame from the wheelchair.
Tools Required:- 13mm Spanner, 4 and
6mm Hexagon Keys.

Remove the Backrest Padding Cover.

Remove two retaining screws from the
upper Adjustment Panel Fig.14 and
manoeuvre the Panel upwards and over
the Push handles to remove.
[Cont]
Fig.13
Fig.12
Adjustable
Support
Straps
Fig.14
Upper Panel retaining screws
Lower Panel retaining screws