1EnIDL5000HD-print.fh10 1/18/06 12:53 PM Page 17
Composite
C
M
Y
CM
MY
CY CMY
K
6.6.3.8 Motor Settings
If you wish to connect the receiver to a rotating antenna (DiSEqC Level 1.2), call up the Main Menu, then
pressing Installation / Setup, then pressing “ Outdoor Settings”, then go to entry “ LNB Type” and use the
/ directional keys to select the setting “Motorized” for every LNB number, which has to be controlled by
the motor. Where you will find a facility for setting the position of the antenna manually for the various
satellite positions, and can then store these positions in memory. In the window “ Motor settings”, select
from the displayed list the satellite you want to reach with the next antenna position. The receiver at this
stage has already registered which transponders are available on this satellite, and will indicate the signal
strength and quality in the form of a bar graph. You can use this to find the optimum for the antenna.
In order to rotate the antenna towards the East or West, use the directional keys to select either “Move
coarse” or “More fine”. When the satellite position has been found, select “Save Position” in order to store
this permanently. In future, the receiver will automatically turn the antenna to this position whenever you
tune to a programmed slot available from this position.
Apart from storing all required satellite positions, you should also make a point of programming an easterly
and a westerly limit position for the motor. This is particularly important if other buildings or structures in
the vicinity restrict the rotation of the antenna. These could damage the antenna, motor or surrounding
objects if pre-programming does not restrict the limit of rotation.
6.6.4 Channel Search
New digital satellite TV and radio program are added almost on a
day daily basis, or existing program will change their frequency.
If you wish to receive these programs, you must allocate them to
specific program slots in the program list, and store them in memory.
The program search function is designed to assist you in this
activity, and there are various types of program search available.
Several procedures can be followed in order to initiate a program
search. Press the “Menu” key to call up the Main Menu, then using
the / directional keys select the sub-menu “Installation / Setup”,
followed by “Channel Search”, confirming your selection in each
case by pressing the “OK” key. Here you can decide between the
three options.
6.6.4.1 Quick Search
Use the automatic program search to allow your receiver to search
through an entire satellite position for new program. In this case,
the entire frequency range of the satellite is searched. The following
information must be input to the receiver:
Satellite: First select the satellite position to be searched. Below
this you will see a display of the current signal strength.
All newly found program would now be displayed on the following
page. At the end, the result of the program search will be displayed.
The search procedure can be terminated at any time by pressing
the “EXIT” key.
