Inverness Medical Inratio2, Руководство пользователя

Страница: 20 / 36

EN
20
8. Turn the monitor OFF when you are finished testing
To turn the monitor off, press and hold the button for about two seconds. Remove the
used test strip when prompted, and discard it in a Sharps or other puncture proof container.
If using batteries, the monitor will turn off automatically if you leave it unattended for a few
minutes. If using the power supply, the monitor will stay on indefinitely. It is recommended
that you turn the monitor OFF manually to conserve power.
Before turning the monitor OFF, you also have the option to:
1. Perform another test
Remove and discard the used test strip, then begin again at step 2 with a fresh test strip,
using a different finger for the fingerstick sample.
2. Review past results in the monitor memory
Press the Memory button to enter Memory mode (see Reviewing Past Results in
Monitor Memory in Section 10 for reviewing past results).
3. Change the monitor settings
Press the Setup button to enter Setup mode (see Changing the Monitor Settings in
Section 7 for changing your monitor settings).
9. Collecting a Fingerstick Sample
Follow these steps to obtain a drop of blood from a finger.
CAUTION: It is important that you use the correct technique and a 21
or 23 gauge lancet to obtain the right type and amount of blood sample.
Failure to do so may cause inaccurate results. If you use another type of
lancing device or lancet, make sure to follow the instructions that came
with that device to get the correct blood sample.
1. Prepare sampling supplies
• Lancet
• Alcohol pad
• Gauze
• Sharps or other puncture resistant
container