INVENTOR P8MVI32-09WiFi, Руководство по обслуживанию, Страница: 43 / 72

41
If the memorization condition is forced
cooling mode, the unit will run in cooling
mode for 30 minutes and turn to auto
mode as 24
℃
setting temperature
If AC is off before power off and AC is
required to start up now, the compressor
will have 1 minute delay when power on.
Other conditions, the compressor will
have 3 minutes delay when restarts.
10.4.9 Refrigerant Leakage Detection
With this new technology, the display
area will show “EC” when the outdoor
unit detects refrigerant leakage.
10.4.10 8
℃
Heating(optional)
In heating operation, the preset
temperature of the air conditioner can be
as lower as 8
℃
, which keeps the room
temperature steady at 8 ℃ and prevents
household things freezing when the
house is unoccupied for a long time in
severe cold weather.
10.4.11 Self clean(optional)
For heat pump models which are
provided with this function, after running
in cooling or drying mode, if the user
press “Self Clean” button on remote
controller, firstly, indoor unit runs in fan
only mode for a while, then low heat
operation and finally runs in fan only
again. This function can keep the inside
of indoor unit dry and prevent breeding
of mold.
10.4.12 Follow me(optional)
1) If the indoor PCB receives the signal
which
results from pressing the FOLLOW ME
button on remote controller, the buzzer
will emit a sound and this indicates the
follow me function is initiated. But when
the indoor PCB receives signal which
sent from remote controller every 3
minutes, the buzzer will not respond.
When the unit is running with follow me
function, the PCB will control the unit
according to the temperature from follow
me signal, and the temperature
collection function of room temperature
sensor will be shielded, but the error
detective function of room temperature
sensor will be still valid.
2) When the follow me function is
available,
the PCB will control the unit according to
the room temperature from the remote
controller and the setting temperature.
3) The PCB will take action to the mode
change information from remote
controller signal, but it will not affected
by the setting temperature.
4) When the unit is running with follow
me
function, if the PCB doesn’t receive any
signal from remote controller for 7
minutes or pressing FOLLOW ME button
again, the follow me function will be
turned off automatically, and the
temperature will control the unit
according to the room temperature
detected from its own room temperature
sensor and setting temperature.
10.4.13 Silence operation(optional)
Press the “silence” button on remote
controller to initiate SILENCE function.
When the Silence function is activated,
the compressor running frequency will
keep lower than F2 and the indoor unit
will bring faint breeze, which will reduce
the noise to the lowest level and create a
quiet and comfortable room for you.
10.4.14 Easy control(optional)