5
ZR10-D controller
•
Installation and operating instructions
Where several different hazard levels coincide, the warning notice for the highest level is always
used.
In addition to the safety instructions, an information symbol provides practical and useful tips for
using the controller
noTe
Additional useful information.
1.3
Intended use
When installing the controller, observe the applicable building codes, ire protection regulations and
accident prevention regulations of the Employer's Liability Insurance Association.
Only use the controller in accordance with the applications described in this documentation and only
in combination with the components recommended, approved and speciied by inVENTer GmbH in
this documentation. Changes and modiications to the controller are not permitted.
Trouble-free and safe operation of the controller can only be ensured provided it is transported,
stored and assembled correctly and operated and maintained with care. This documentation forms
part of the controller and must be available at all times. Observe all safety regulations in this
documentation.
This installation and operating instructions is only valid with the installation and operating instruc-
tions of the iV12-Smart, iV12-Smart Corner, iV12-Smart Ohio, iV14R, iV14R-Corner, iV14R-Ohio,
iV14R-Sylt, iV14V, iV14V-Ohio, iV14V-Corner, iV25, and iV-Twin ventilations systems and supple-
ments them. All legal notices given in the installation and operating instructions also apply to this
document without limitation. This applies to Warning Notice Design, Qualiied Personnel
, Intended
Use, Trademarks and Exclusion of Liability.
1.4
Unauthorised use
The controller is exclusively intended for the control of the iV12-Smart, iV12-Smart Corner, iV12-S
-
mart Ohio, iV14R, iV14R-Corner, iV14R-Ohio, iV14R-Sylt, iV14V, iV14V-Ohio, iV14V-Corner, iV25,
and iV-Twin ventilation units. Any other use is strictly prohibited.
1.5
Qualiied personnel
The controller may only be installed and operated in combination with this documentation. Instal-
lation, electrical connection and initial start-up of the controller may only be performed by qualiied
personnel.
Qualiied personnel within the meaning of the safety information in this documentation are persons
authorised to install, start up and identify equipment, systems and electrical circuits in accordance
with safety engineering standards.
safeTy
