Operation
Adjusting T-Arm Depth
1.
Remove the two mounting screws
C
that secure the arm pad
A
to the arm tube
D
.
2.
Remove the two socket screws
B
that secure the arm tube
D
to the T-arm post
E
.
3.
Reposition the arm tube
D
on the T-arm post
E
:
•
Desk Length Arms - to one of three positions depending on
the desired arm pad
A
depth.
•
Full Length Arms - to one of five positions depending on
the desired arm pad
A
depth.
Additional positions are obtainable by turning the
arm tube 180°.
4.
Re-secure the arm tube
D
to the T-arm post
E
with the two
socket screws
B
. Torque to 60-70 in./lbs (152.4–177.8cm/kg).
5.
Reattach the arm pad
A
to the arm tube
D
with the two
mounting screws
C
. Tighten securely.
6.
Repeat for the opposite side, if necessary.
4.6 Adjusting T-Arm Sockets
Perform this procedure if the T-arm
A
is too loose in the
socket or does not easily slide up and down in the socket.
1.
Remove the rear wheels from the wheelchair, if necessary. Refer
to 5.7 Removing/Installing Rear Wheels, page 52.
2.
Loosen, but do not remove the four socket screws and washers
E
that secure outer T-arm bracket
D
to the inner T- arm
bracket
C
.
The T-arm socket will disassemble if the four socket
screws and washers
E
are removed.
1171801-A
33
