Top End
®
Terminator™Series
3.
Slide the T-arm
A
into the T-arm socket until the locking lever
F
is in the slot
B
in the T-arm socket and an audible "click" is
heard.
4.
Squeeze the outer T-arm bracket
D
and the inner T-arm bracket
C
together until the socket is flush with the T-arm
A
.
5.
While holding the outer and the inner T-arm brackets together,
tighten the four socket screws and washers
E
. Tighten securely.
6.
Press in on the locking lever
F
and lift the T-arm straight up
and out of the T-arm socket.
7.
Repeat STEPS 3-6, if necessary until the T-arm
A
slides in the
T-arm socket as desired.
8.
If necessary, install rear wheels. Refer to 5.7 Removing/Installing
Rear Wheels, page 52.
4.7 Adjusting Quick-Release Axles
1.
Remove rear wheel and quick-release axle
B
from the
wheelchair. Refer to 5.7 Removing/Installing Rear Wheels, page
52 and to 5.10 Replacing Quad-Release Axles, page 54.
2.
Depress detent pin
A
in the quick-release axle
B
and slide axle
through the wheel hub
C
.
3.
Release detent pin
A
ensuring that the locking pins
D
are fully
released.
4.
Increase or decrease end play by adjusting the locknut
E
on the
end of the quick-release axle
B
.
5.
Install rear wheel onto the wheelchair. Refer to 5.7
Removing/Installing Rear Wheels, page 52 .
End of Quick Release axle is shown for reference only. It is
not visible when inserted into camber bar.
34
1171801-A
