Invacare® Storm®⁴ Max
Fig. 8-6
The safety belt installed in the transporting vehicle should
be applied as shown in the illustration above.
1) Center line of the body
2) Center of the sternum
8.4 Transporting Mobility Device Without
Occupant
CAUTION!
Risk of injury
– If you are unable to fasten your mobility
device securely in a transport vehicle, Invacare
recommends that you do not transport it.
Your mobility device may be transported without restrictions,
whether by road, rail or by air. Individual transport
companies have, however, guidelines which can possibly
restrict or forbid certain transport procedures. Please ask
the transport company regarding each individual case.
•
Before transporting your mobility device, make sure the
motors are engaged and that the remote is switched off.
Invacare strongly recommends that you additionally
disconnect or remove the batteries. Refer to Removing
the batteries.
•
Invacare strongly recommends securing the mobility
device to the floor of the transporting vehicle.
8.4.1 Opening Rear Shroud
Removing Rear Shroud
1.
Loosen and remove two hand screws (1) on left and
right side of rear casing.
2.
Lift rear shroud carefully. Front part of shroud is held at
top by hook and loop strip. This must also be released.
Installing Rear Shroud
1.
Install parts in reverse order.
2.
Tighten hand screws by hand.
58
1547067-H
Содержание Storm 4 Max
Страница 74: ...Notes ...
Страница 75: ...Notes ...
Страница 76: ...Notes ...
Страница 77: ...Notes ...