Part No. 1114822
29
Tilt/Recline Seating Systems®
RIGGINGS
SECTION 8
FOOTPLATE HEIGHT (FIGURE 3).
NOTE: The following procedure should be performed with the user in the wheelchair.
1. Loosen, but do not remove the bolt and
locknut that secure the lower legrest
assembly to the upper legrest assembly.
2. Move the lower legrest assembly to the
desired position for the user.
3. While holding the lower legrest in
position, tighten the bolt and locknut
securely.
4. Repeat STEPS 1-4 for opposite legrest if
necessary.
Speed/Height.
NOTE: Mechanical Elevating Legrest speed and height cannot be adjusted independently of the
recline function of the wheelchair. If the mechanical elevating legrests are not operating as de-
sired, have the wheelchair serviced by an Invacare dealer or technician.
ADJUSTING GENIUS LEGRESTS
Footplate Height (FIGURE 4).
1. Note the angle of the footplate in relation to the legrest as shown in FIGURE 4.
2. Loosen, but do not remove the three (3) hex bolts and locknuts that secure the
footplate to the legrest.
3. Adjust the footplate to the desired height.
4. Line up the footplate to the angle noted in STEP 1.
5. While holding the footplate, tighten the three (3) hex bolts and locknuts securely.
Footplate Angle (FIGURE 4).
1. Note the angle of the footplate in
relation to the legrest as shown in
FIGURE 4.
2. Remove the rear hex bolt and locknut
that secure the footplate to the
legrest.
3. Move the footplate to the desired angle.
4. Install the hex bolt through the mount-
ing holes that correspond to the
desired footplate angle.
5. Install the locknut onto the hex bolt.
6. Line up the footplate to the angle
noted in STEP 1.
7. While holding the footplate, tighten the hex bolt and locknut securely.
FIGURE 3 - ADJUSTING
MECHANICAL ELEVATING
LEGRESTS - FOOTPLATE HEIGHT
Lower Legrest
Assembly
Upper
Legrest
Assembly
Bolt/Nut
FIGURE 4 - ADJUSTING GENIUS
LEGRESTS - FOOTPLATE
HEIGHT/ANGLE
Hex Bolts
and
Locknuts
Footplate
Legrest
Rear Hex Bolt
and Locknut
Rear Hex Bolt
and Locknut
RIGGINGS
