Tilt/Recline Seating Systems®
18
Part No. 1114822
This Section Includes the Following:
Operating Tilt Only Systems
OPERATING TILT ONLY SYSTEMS (FIGURE 1)
WARNING
NEVER operate the wheelchair while in any tilt/back angle combination
over 20
o
RELATIVE TO THE VERTICAL POSITION. If the drive lock-out
does not stop the wheelchair from operating in a tilt/back angle combina-
tion 20
o
RELATIVE TO THE VERTICAL POSITION, DO NOT operate
the wheelchair. Have the wheelchair serviced by a dealer or qualified
technician.
Use only TAC, SAC, TRSS and TRCM actuator controls to activate the
tilt/recline functions. DO NOT USE any other actuator controls. Such
devices may result in excess heating and cause damage to the actuator
and associated wiring and could cause a fire, death, physical injury or
property damage. If such devices are used, Invacare shall not be liable and
the limited warranty is void.
A NOTE ABOUT DRIVE LOCK-OUT
Drive lock-out is a safety feature designed to prevent the wheelchair from being driven
while in any recline/back angle combination over 20
o
RELATIVE TO THE VERTICAL
POSITION. When the drive lock-out feature has been activated, the LED on the single
function toggle switch will light.
NOTE: The tilt angle range is from 0
o
to 45
o
with a 0
o
seat-to-floor angle and 5
o
to 50
o
with a 5
o
seat-to-floor angle.
SINGLE FUNCTION TOGGLE SWITCH
Increasing Tilt Angle.
1. Make sure the wheelchair is on a level surface.
2. Pull single function toggle switch back towards rear of the wheelchair until the
desired angle is achieved.
Decreasing Tilt Angle.
1. Push the single function toggle switch forward toward the front of the wheelchair
until the desired angle is achieved.
OPTIONAL FOUR-WAY TOGGLE SWITCH
Increasing/Decreasing Tilt Angle.
1. Make sure the wheelchair is on a level surface.
2. Push four-way toggle switch forward toward the front of the wheelchair until the
desired tilt angle is achieved.
TILT ONLY
SECTION 3
TILT ONLY
