SECTION 14—BACK
70
Part No 1125031
Removing/Installing the Contoura Back
NOTE: For this procedure, refer to FIGURE 14.2 on page 71.
Removing the Contoura Back
1. Remove back cushion.
2. Remove the two mounting screws that secure the lower front mounting brackets to the
back canes.
3. Remove the four socket screws, washers and locknuts (not shown) that secure the four
front and rear mounting brackets.
4. Remove the Contoura back and hardware from the back canes.
Installing the Contoura Back
1. Position the front mounting brackets against the back canes.
2. Secure the lower front mounting brackets to the back canes using the two mounting
screws. Torque to 32 in-lbs ± 20%.
3. Insert the tab of the rear mounting bracket into the slot in the front mounting bracket.
4. Secure the four rear mounting brackets to the four front mounting brackets using the
four socket screws, washers and locknuts (not shown). Torque to 75 in-lbs ± 20%.
5. If necessary, tighten the socket screws and locknuts securing the front mounting
brackets to the slot in the Contoura back. Torque to 75 in-lbs ± 20%.
Removing the Mounting Hardware from the Contoura Back
1. Remove the four socket screws, eight washers and four locknuts that secure the front
mounting bracket to the Contoura back.
2. Remove the hardware from the back.
Installing the Mounting Hardware onto the Contoura Back
1. Secure two of the front mounting brackets to the mounting holes in the Contoura back
using two socket screws, four washers and two locknuts. Torque to 75 in-lbs ± 20%.
2. Loosely attach the remaining two front mounting brackets to the slots in the Contoura
back using two socket screws, four washers and two locknuts.
NOTE: The two socket screws and locknuts will be tightened when the Contoura back is installed
onto the back canes.
3. Install the Contoura back. Refer to Installing the Contoura Back on page 70.
