SECTION 22—TDX BATTERIES
Part No 1125031
175
Removing/Installing the Batteries From/Into the
Wheelchair
Removing the Battery Door and Rear Shrouds
CAUTION
Place the wheelchair in a well ventilated area where work can be performed with-
out risking damage to carpeting or floor covering.
NOTE: For this procedure, refer to FIGURE 22.3 on page 176 and FIGURE 22.4 on page 177.
1. Verify the joystick On/Off switch is in the Off position.
2. Remove the two thumb screws that secure the rear shroud to the wheelchair.
3. Remove the rear shroud from the wheelchair.
4. TRRO and TRBKTS Options Only - Perform the following steps:
A. Remove two thumb screws that secure the top controller shroud (FIGURE 22.4) to
the battery box.
B. Remove the top controller shroud from the battery box.
5. Tilt the PTO Plus back. Refer to Tilting the Seat Assembly on page 81.
6. Remove both mounting screws from side of battery door.
7. Remove the battery door from the front of wheelchair.
8. TRRO and TRBKTS Options Only - Perform the following steps (FIGURE 22.4):
A. Remove the four screws and four locknuts (if applicable) that secure the battery
support bracket to the battery box.
B. Remove the battery support bracket.
9. Disconnect the controller from the batteries at the rear of the wheelchair.
10. Remove the batteries. Refer to Removing the Batteries from the Wheelchair on
