Invacare Crossfire All Terrain, Руководство пользователя

Страница: 55 / 88

Operation
4.19 Adjusting/Replacing Anti-tipper
WARNING!
–
After ANY adjustments, repair or service and BEFORE
use, make sure all attaching hardware is tightened
securely - otherwise injury or damage may occur.
WARNING!
– Anti-tippers must be attached at all times. Inasmuch as
the anti-tippers are an option on this wheelchair (you
may order it with or without the anti-tippers), Invacare
strongly recommends ordering the anti-tippers as an
additional safeguard for the wheelchair user.
–
Anti-tippers must be fully engaged. Ensure the lock
buttons of the anti-tippers fully protrudes out of the
mounting hole in the anti-tipper bracket.
–
Ensure both anti-tippers are adjusted to the same
height.
Measurements for anti-tippers are approximate and are
taken using the top adjustment hole on the anti-tipper
(Detail “A”).
Adjusting Anti-Tipper
WARNING!
–
When anti-tippers are used, anti-tippers MUST be
adjusted to maintain a 1-1/2 to 2-inch clearance
between the bottom of the anti-tipper wheels and
the ground/ floor. This spacing should ALWAYS be
checked whenever adjustments/changes are made to
the wheelchair. Failure to maintain proper spacing
may result in the chair tipping over backward causing
serious injury or property damage.
1. Press in the lock button
C
that secures the anti-tipper wheel
assembly to the anti-tipper bar
E
.
2. Adjust the height of the anti-tipper wheels to between 1-1/2 and
2-inches
G
of the ground/floor
D
.
3. Repeat STEPS 1-2 for the opposite anti-tipper B .
Replacing Anti-Tipper
WARNING!
– When anti-tippers B are used, anti-tippers B MUST
be adjusted to maintain a 1-1/2 to 2-inch clearance
G
between the bottom of the anti-tipper wheels and
the ground/floor
D
. This spacing should ALWAYS be
checked whenever adjustments/changes are made to
the wheelchair. Failure to maintain proper spacing
may result in the chair tipping over backward causing
serious injury or property damage
.
1. Press in the release button A that secures the existing anti-tipper
B
to the anti-tipper bracket
H
and remove the anti-tipper
B
from the anti-tipper bracket
H
.
2. Insert the new anti-tipper
B
into the anti-tipper bracket
H
until
lock buttons
C
protrude out of mounting hole
F
.
1134872-D~08 55