Invacare 9000 SL, Руководство владельца по эксплуатации и техническому обслуживанию

Страница: 24 / 45

24
3. Install the two (2) seat extension tubes into the
ends on the crossbraces.
4. Line up the second mounting hole from the rear
of the seat extension tube with the mounting hole
in the crossbrace. Repeat for opposite seat ex-
tension tube.
5. Install the NEW seat upholstery onto the wheel-
chair. Make sure to line up the mounting holes
in the seat extension tubes with the
NEW seat
upholstery. Refer to REPLACING THE SEAT
UPHOLSTERY in this procedure of the manual.
6. Install plug buttons into the ends of the seat ex-
tension tubes.
NOTE: Do not use back mounting hole. If back
mounting hole is used, the mounting hole for
the other mounting screw will not line up prop-
erly.
ADJUSTING BACK ANGLE - 9000XT
ADJUSTABLE BACK MODEL ONLY
WARNING
The back angle and seat depth directly relate
to the stability of the wheelchair. Any change
to one (1) or any combination of the two (2)
may cause the wheelchair to decrease in sta-
bility. The following procedure MUST be per-
formed by an authorized Invacare dealer or
qualified technician.
ADJUSTING THE SEAT WIDTH - 9000SL,
9000XT, 9000XDT
WARNING
Adjusting the seat width of the 9000SL, 9000XT,
9000XDT MUST be performed by an authorized
Invacare dealer or qualified technician.
PROCEDURE 6 SEAT AND BACK
S
E
A
T
A
N
D
B
A
C
K
Plug Button
Crossbrace
Mounting
Screws
Seat Upholstery
Seat
Extension
Tube
Second
Mounting
Hole
FIGURE 7 - ADJUSTING SEAT DEPTH -
9000XDT
NOTE: This illustration depicts the 1-inch seat
extension. The 2-inch seat extension attaches
in the same manner.
DO NOT use this
back mounting hole.
Washer