Invacare 9000 SL, Руководство владельца по эксплуатации и техническому обслуживанию

Страница: 35 / 45

35
With Attendant Operated Wheel Locks
(FIGURE 10)
1. Remove the axle mounting screw and locknut
that secure the rear wheel and spacer to the
wheelchair frame.
2. Remove rear wheel from side frame.
3. Secure rear wheel and spacer to wheelchair
frame with axle mounting screw and locknut. Se-
curely tighten.
FIGURE 10 - REMOVING/INSTALLING THE
REAR WHEELS - WITH ATTENDANT
OPERATED WHEEL LOCKS
R
E
C
L
I
N
E
R
RECLINER PROCEDURE 10
Locknut
Wheelchair
Frame
Rear
Wheel
Axle
Mounting
Screw
Spacer
APPLY
PRESSURE
HERE TO
DISENGAGE
LOCKED
POSITION
APPLY PRESSURE
HERE TO ENGAGE
UNLOCKED
POSITION
FIGURE 11 - USING ATTENDANT OPERATED
WHEEL LOCKS
Adjusting
ATTENDANT OPERATED WHEEL LOCKS
(FIGURE 12).
NOTE: If wheels are pnematic, before adjusting
or replacing the wheel lock assemblies, ensure
that the tires are inflated to the recommended psi
located on the side wall of tire.
1. Loosen the bolt and locknut that secure the wheel
lock to the recliner tube.
2. Adjust the position of wheel lock until the measure-
ment between the rear wheel and the wheel lock
shoe is between 5/32 and 5/16-inches.
3. Securely tighten the bolt and locknut.
4. Engage wheel lock and push against the wheel-
chair and determine if wheel lock engages the
wheel lock shoe enough to hold the wheelchair.
5. Repeat the above procedures until the wheel lock
holds the wheelchair.
USING/ADJUSTING THE WHEEL LOCKS
NOTE: For Using and/or Adjusting of Patient Oper-
ated Wheel Locks, refer to USING/ADJUSTING THE
PATIENT OPERATED WHEEL LOCKS in PROCE-
DURE 9 of this manual.
Using
ATTENDANT OPERATED WHEEL LOCKS
(FIGURE 11).
WARNING
DO NOT attempt to stop a moving wheelchair
with the wheel locks. WHEEL LOCKS ARE NOT
BRAKES.
1. Perform one (1) of the following:
A. ENGAGE - Apply pressure downward on
wheel lock handle.
B. DISENGAGE - Lift up on wheel lock handle.