Intimus INT-GU-05280EPSP, Руководство по эксплуатации

Страница: 60 / 86

Operation Manual 5280 EPSP
60
•
DANGER!
Caution – Fire hazard with insufficient ventilation!
The machine guards must be put back into place immediately after
maintenance work has been completed!
9.3 Lubrication
The list of lubrication points is shown in Figures 44, 45, 46, 47, 48 and described in table 10.
Access to lubrication points is possible after removing the covers shown in Figs. 42, 43, 46,
48. When lubricating the knife assembly, use the controls as when changing the knife
(Chapter 8.1). In places requiring lubrication with a grease, apply grease with a grease gun.
It is enough to press the trigger of the lubricator 2-3 times.
The indicated points should be lubricated once a week!
Table 10. List of lubrication points of the cutter mechanisms
Mark
Cutter
mecha
nism
Type of
lubricant
Lubrication point Figure
Knife Grease
• Side surfaces of the guides (in contact with
the knife body)
• Internal surfaces of guides (in contact with
rollers)
• Side surfaces of the knife body
44,45
Backgu
age
Oil
•
guide roller (apply a thin layer of oil.)
• lead screw (apply a thin layer of grease)
45
46
Clamp Grease
• the pressure beam slides
• shaft bearings
• the surface of the gears
• tie rod - pin
• gear bearings 2 (fig.47)
45
47
47
47
48
1
2
3