Intimidator eNVy neighborhood vehicle, Руководство пользователя

Страница: 124 / 128

Summit Series
®
II
User’s Manual
12.2 Charger LED Faults
The charger will indicate when a fault occurs by using different patterns of the Fault (Red), Charge Status
(Yellow), and Charge Complete (Green) LEDs as explained in the table below. Using the ChargerConnect
App, check the diagnostic tab to get a description of the charger fault.
FAULT
(Red) LED
CHARGE
STATUS
(Yellow) LED
CHARGE
COMPLETE
(Green) LED
DESCRIPTION
Ch
ar
g
e
r
Slow Blink Solid On Solid On
DC DISCONNECT – DC disconnect detected via
the third-pin, but DC (battery) voltage is still present
at the charger output.
Slow Blink Off Solid On
OVER TEMP – Maximum temperature was met.
Charge cycle was halted and will restart when the
temperature decreases.
Slow Blink Fast Blink Slow Blink
LOW TEMP – Temperature is too low to start a
charge cycle (< -25°C). Charging will start when
temperature increases.
Slow Blink Solid On Off
LOW DC – DC (battery) voltage is too low to start
charging (< 10V).
Slow Blink Off Off
NO AC – AC power was lost during charging.
Charge cycle was halted and will restart when AC
power returns.
Slow Blink Solid On Slow Blink HARDWARE FAULT – Contact Lester Electrical.
Slow Blink Slow Blink Off HARDWARE FAULT – Contact Lester Electrical.
Slow Blink Slow Blink Slow Blink
COMM FAULT – LEDs blink one at a time in a
rotating pattern. Contact Lester Electrical. Unit is still
able to charge.
Slow Blink Slow Blink Solid On HARDWARE FAULT – Contact Lester Electrical.
Fast Blink N/A N/A
HARDWARE FAULT – Contact Lester Electrical.
Unit is still able to charge.
Bat
ter
y
Solid On Off Off
PHASE – A fault condition (most commonly
maximum time) was met during a particular charge
phase (start/bulk, plateau/absorption, finish, etc).
Solid On Off Slow Blink MAX VOLTAGE – Maximum voltage was met.
Solid On Off Solid On
MIN VOLTAGE – Minimum voltage was NOT met
after a specified time from the start of the charge.
Solid On Slow Blink Off
MAX AMP-HOURS – Maximum amp-hours for the
overall charge cycle was met.
Solid On Slow Blink Slow Blink
MAX TIME – Maximum time for the overall charge
cycle was met.
Solid On Solid On Fast Blink
BATTERY TEMP – Battery temperature is outside of
its specified range
N/A = Not applicable, LED state does not matter
124