292
IO
S AVE THESE INSTRUCTIONS
(292IO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 07/15/2016
English
Page 8
PRODUCT SPECIFICATIONS
SET UP
Cord-connected spa with pump, heater, blower, built-in hard water treatment and control panel.
The water heating function heats the water on the spa (A) side only.
The
fi
ltration system is designed to
fi
lter one side of the tub at a time only.
This product requires a minimum of 13 Amps. If the circuit breaker trips, please check that no other
appliances or other large loads are on the same circuit as the spa.
Site preparation and requirements
• For outdoor installation only. For household use only.
• Make sure the area is free of sharp objects under or around the spa.
• Provide a properly located power outlet to connect the spa and allow easy access for periodic testing of the
cord mounted RCD.
• Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and/or service.
• The area shall facilitate draining purposes during long term spa storage.
• Make sure the
fl
oor is water resistant and non-slip surface. Do not install the spa on carpet or other
materials that will be damaged by moisture, condensation.
• Spa owners may need to comply with local or states laws relating to childproof fencing, safety barriers,
lighting, and other safety requirements. Contact your local building code enforcement of
fi
ce for further
details.
• Do not setup the spa on grass or dirt, as this increases the amount of debris entering the spa, and damage
the spa
fl
oor.
• Do not expose the spa to direct sunlight for extended period of time.
• It is possible to install and leave the spa outside at a temperature not lower than 4°C (39°F) provided the
water temperature inside the spa is higher than 4°C (39°F) and the water inside the circulation system,
pump, pipe are not frozen. Put a “temp barrier mat” between the spa
fl
oor and the ground to prevent heat
loss from the bottom of the spa and to provide better heat retention.
Maximum seating capacity:
4 adults
"A" side water capacity:
210 gal (795 L)
"B" side water capacity:
310 gal (1,173 L)
Inner/outer size:
152"(3.86M)
72"(1.83M)
50"(1.27M)
72"(1.83M)
52"(1.32M)
106"(2.69M)
B
A
Height:
28 in (71 cm)
Bubble air blower:
1.1 HP / 220-240 V / 50 Hz
Filter pump
fl
ow rate:
323 gal/hr (1,222 L/hr)
Heater power:
2,200 Watts / 220-240 V / 50 Hz
Spa temperature range:
20ºC – 40ºC (68ºF – 104ºF)
Spa temperature rise:
1.5-2.5ºC/hr (3ºF – 4.5ºF/hr)
"A" side number of Bubble Jets:
120
"B" side number of Bubble Jets:
150
Tub Liner and bench recommended
working air pressure:
0.083 bar (1.2 psi)
