341
PO
SAVE THESE INSTRUCTIONS
(341PO) MODEL SF90110-1 SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U
04/01/2021
English
Page 12
SETUP INSTRUCTIONS (continued)
Motor installation:
1.
Place an L-shape o-ring
(18)
on the pump motor outlet. In a clockwise motion connect the
sand filter interconnecting hose
(13)
to the pump motor outlet
(see drawing 20)
.
2.
Connect the pump motor unit to the tank support base
(see drawing 21.1)
. NOTE: Ensure
the leaf trap water inlet hose connection is facing towards the pool.
IMPORTANT: Some countries, especially in the European community, require the
product to be secured to the ground or to a base in a permanent upright position.
Check your local authorities to determine if there is a regulation in your area
regarding above-the-ground swimming pool filter-pumps. If yes, then the product can
be mounted to a platform using the two holes located in the base. See drawing 21.2.
The product can be mounted on a cement base or onto a wooden platform to prevent
accidental falling over.
•
The mounting holes are 6.4 mm in diameter and spaced 196.5 mm apart.
•
Use two bolts and lock nuts with a maximum of 6.4 mm in diameter.
3.
Place an L-shape o-ring
(11)
on the 6-way valve inlet connection. In a clockwise motion
connect the sand filter interconnecting hose
(13)
to the 6-way valve inlet connection
(see
drawing
22)
.
21.1
22
13
20
13
21.2
196.5 mm
