341
PO
SAVE THESE INSTRUCTIONS
(341PO) MODEL SF90110-1 SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U
04/01/2021
English
Page 9
PRODUCT SPECIFICATIONS
SETUP INSTRUCTIONS
The sand filter removes suspended particles but does not sanitize your pool. Pool
chemistry is a specialized area and you should consult your local pool service specialist
for details.
TOOLS REQUIRED:
One (1) Phillips screwdriver
Pump location and mounting:
•
The system must be installed on a solid level and vibration-free base.
•
Provide a location protected from the weather, moisture, flooding and freezing
temperature.
•
Provide adequate access, space and lighting for routine maintenance.
•
Pump motor requires free circulation of air for cooling. Do not install the pump in a
damp or non-ventilated location.
A team of 2 or more people is recommended for setting up this product.
Leaf trap setup:
1.
Make sure the pump o-ring
(6)
is in place. In a clockwise motion screw the leaf trap
(19)
onto the motor inlet
(see drawing 10)
.
Sand tank installation:
1.
Place the tank support base at the selected location.
2.
Place the tank on the tank support base
(see drawing 11.1)
.
11.2
10
19
6
11.1
11.3
Power:
110-120 Volt AC
Amperage:
1.8 A
Maximum working pressure:
1.4 bar (20 psi)
Effective filtering area:
0.05 m
2
(0.54 ft
2
)
Maximum Flow Rate:
4000 liters/hour (1050 gallons/hour)
Recommended filtering media:
No. 20 silica sand or glass sand. Particle size
(Not included)
range 0.45 to 0.85 mm (0.018 to 0.033 inches).
Uniformity Coefficient less than 1.75.
Recommended filtering media quantity: No. 20 silica sand 12 Kg (26 Lbs) or glass sand
8.5 Kg (18.5 Lbs).
Limited Warranty:
see “Limited Warranty”
