27
JUNG® thermostats temperature control
This type of device is used for the JUNG® thermostats control, where it is not
allowed to modify the set-point temperature through the 2 bytes group address. By
the means of the 1Byte group address used, we get the same behavior than the
thermostat adjustment wheel.
The group addresses to configure are:
-
Modification entrance set-point 1Byte:
temperature’s base value.
-
Set-point temperature 2Byte:
temperatures visualization.
-
Modification set-point status 1Byte:
temperatures base value status.
For the correct functioning of the device, it is important to check that the reading flag
of the feedback in the ETS has been activated.
