31
137750_Rev_L 11.16.12
5. Push in gas control knob slightly and turn clock-
wise to “OFF”.
NOTE: Knob cannot be turned from “PILOT” to
“OFF” unless the knob is pushed in slightly. Do
not force.
6. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow “B” in the safety
information above on this page. If you do not
smell gas, go to the next step.
1. Turn ON/OFF switch to” OFF”. The pilot will
remain lit for normal service.
2. For complete shutdown, turn ON/OFF switch to
“OFF”.
FOR YOUR SAFETY, READ BEFORE LIGHTING.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO THE APPLIANCE:
LIGHTING INSTRUCTIONS
WARNING:
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUS-
ING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A. This appliance has a pilot which must be lit
by hand. When lighting the pilot, follow these
instructions exactly.
B. BEFORE LIGHTING, smell all around the appli-
ance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and
will settle to the floor.
WHAT TO DO IF YOU SMELL GAS:
• Extinguish any open flame.
• Open windows.
• Do not light any appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone.
• If your gas supplier cannot be reached, call the
fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, do not try to repair it.
Call a qualified technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to re-
place any part of the control system and any gas
control which has been under water.
1. STOP! Read the safety information above.
2. Access the lower controls.
3. Turn the stove ON/OFF switch to “OFF”, or set the
thermostat to lowest setting (if used).
4. Confirm that the gas supply line shut-off valve is
open.
Pilot Assembly
7. Push in gas control knob slightly and turn
counterclockwise to “PILOT”.
8. Push in control knob all the way and hold in.
Immediately light the pilot by triggering the
spark ignitor (push the red button repeatedly)
until pilot lights. Continue to hold the control
knob in for about one
minute after the pilot
lights. Release knob and
it should spring back.
The pilot should remain
lit. If it goes out, repeat
Steps 5 through 8.
• If knob does not
return when released,
stop and immediately call your service techni-
cian or gas supplier.
• If pilot will not stay lit after several tries,
turn the control knob to OFF and call your
service technician or gas supplier.
9. Turn gas control knob counterclockwise
to “ON”.
10.Turn the stove ON/OFF switch to “ON”, or set
thermostat (if used) to desired temperature.
Control
Knob
OFF
PILOT
ON
3. Access the lower controls.
4. Depress gas control knob slightly and turn clockwise
to OFF”. Do not force.
Control Valve
