Interroll Roller Conveyor SH 1110
Maintenance and repair
Version 1.0 (06/2022) en
Translation of original operating instructions
43
Preparatory and follow-up maintenance work
WARNING
Risk of injury from crushing and electrocution
Installation and maintenance tasks on a conveyor system while it is in operation can cause
crushing and electric shock.
4
Power down the entire conveyor module and ensure that it cannot be started accidentally.
Fasten screws with a tightening torque of 19 Nm.
Removing/installing the
end plate
1
1
2
End plate
1
Torx screw
2
End plate
The installation of the end plate is required at the end of the conveyor section and for
connections with other module belt conveyors.
The removal of the end plate is required at connections with other roller conveyors or roller
curves.
Requirement:
R
The module is shut down.
4
Unscrew screws (1) and remove end plate (2) from the C-profile of the side frames.
4
After the maintenance work: Fasten end plate (2) with two screws (1) each on the right and
left at the side frames.
