44
TruVision Series 5 IP Camera Configuration Manual
To define intrusion detection:
1. From the menu toolbar, click
Configuration
>
Smart Event
>
Intrusion Detection
.
2. Select the
Enable Intrusion Detection
check box to enable the function.
3. Click
Draw Area
, and then draw a rectangle on the image as the defense region.
When you draw the rectangle, all lines should connect end-to-end to each other. Up
to four areas are supported. Click
Clear
to clear the areas you have drawn. The
defense region parameters can be set up separately.
Note
: The area can only be quadrilateral.
4. Choose the region to be configured.
Threshold:
This is the time threshold that the object remains in the region. If you
set the value as 0 s, the alarm is triggered immediately after the object enters the
region. The range is between 0 and 10.
Sensitivity:
The sensitivity value defines the size of the object that can trigger the
alarm. When the sensitivity is high, a small object can trigger an alarm. The range is
between 1 and 100.
5. Click
Edit
to set the arming schedule for the alarm input. See “Motion detection
alarms” on page 30 for more information.
6. Specify the linkage method when an event occurs. Check one or more response
methods for the system when an intrusion detection alarm is triggered.
Notify Alarm Recipient
Send an exception or alarm signal to remote management
software when an event occurs.
Send Email
Send an email to a specified address when there is a motion
detection alarm.
Note
: You must configure email settings before enabling this
option. See “To set up the email parameters” on page 17 for
further information. If you want to send the event snapshot
together with the email, check the Attached Snapshot option.
Upload Snapshot
Capture the image when an alarm is triggered and upload the
picture to NAS or FTP server.
Note
: To upload the snapshot to NAS, you must first configure
the NAS settings. See “NAS settings” on page 49 for further
information.
To upload the snapshot to an FTP, you must first configure the
FTP settings. See “To define the FTP parameters” on page 17
for further information. Enable the
Upload Type
option.
To upload the snapshot to FTP and NAS when motion
detection or an alarm input is triggered, you must also enable
Enable Event-triggered Snapshot
under the snapshot
parameters. See “Snapshot parameters” on page 48 for further
information.
Trigger Channel
Trigger the recording to start in the camera.
Trigger Alarm Output
Trigger external alarm outputs when an event occurs. Check
“Select All” or each individual alarm output.
Note
: This option is only supported by cameras that support
alarm output.