Interlift ILF Series, Руководство по установке

Страница: 7 / 18

6. Before any welding is started, please check that liftgate is balanced and not binding
in mounting fixture, you should have equal pressure on each lift-arm pin. This is
very important to make platform align with truck sill.
7.
Be certain to pull out power tray before welding . The reservoir is made of plastic
and you may burn it while welding. To pull out tray, just simply remove the bolt on
the curbside and detach the ground strap and control power connector for the tray.
Pull on tray until the hoses are stretched and the tank is further out than the point of
welding.
8. Tack weld mount plates to mount tube with a minimum three one inch welds and
three one inch welds to the truck frame.
Before finishing up all welding we
recommend doing the electrical installation and platform installation to make
sure that everything aligns like it should
.
Use a min of 8" overlap between mount plates and truck frame
Weld 100% with 1/4" weld against the frame and both sides
of the plates against the mount frame