Intergraph TD-20 Setup, Руководство по установке

Страница: 49 / 66

37
TD-200 ICU
To create ICU diskettes:
1. From the IBBS login, go to Intergraph Product Centers, Systems and Networking, File
Libraries, and Delivered Drivers; select the operating system and hardware platform.
2. Find the
SYSUTIL
product and download it to a directory on your system.
3. Use an unzip utility to open the
SYSUTIL
product and extract the files from it.
4. Insert a 3.5-inch high-density diskette into the floppy disk drive.
5. In the directory containing the
SYSUTIL
files, run the
INSTALL
.
BAT
program. This creates
two ICU diskettes, one of which is a boot diskette. Change out diskettes as needed,
numbering them 1 and 2 as you remove them to keep them in order.
6. After the
INSTALL
.
BAT
program completes, remove the remaining diskette from the floppy
disk drive. Label the first diskette ICU Diskette 1, and label the second diskette ICU
Diskette 2.
NOTE On a system running Windows NT and using the NT File System (NTFS), you must install the
ICU to a File Allocation Table (FAT) partition on your system’s hard disk drive. ICU installation
will not work on an NTFS-only system because you cannot access NTFS partitions from the
ICU boot diskette. Intergraph recommends creating a 10 MB FAT partition to allow for future
growth of the ICU and its information database.
To install and run the ICU:
1. Insert ICU diskette 1 into the floppy disk drive.
2. Restart the system.
3. At the command prompt, key in install.
4. Follow the prompts to install the ICU to a FAT partition on the hard disk drive.
5. After installing the ICU on the hard disk drive, remove the remaining diskette from the
floppy disk drive.
6. Insert ICU diskette 1 into the floppy disk drive.
7. Restart the system.
8. At the command prompt, change to the ICU directory (for example,
C
:\
PLUGPLAY
\
ICU
)
and key in icu.