Interchange SN5016, Руководство оператора

Страница: 10 / 20

16 Ga. Medium Crown Stapler
Drives 7/16" Crown Staples (1" to 2" / 25 to 51mm)
Model No. SN5016
Item No. 64405
10
Interchange Brands Operator’s Manual
Operating the Stapler
NOTE:
The information contained in this Manual is designed to assist you in the safe
operation of the stapler . Some illustrations in this Manual may show details or attach-
ments that are different from those on your stapler .
Air Supply, Connections and Operating Pressure
Read section titled SAFETY. Make sure of the following before operation:
Air Supply
1 .
Power source (Compressor)
„ Use only clean, dry, regulated compressed air as a power source for this
stapler .
„
NEVER use oxygen or other bottled gases, as an explosion may occur .
„ Air compressors used to supply compressed air to this stapler must comply
with the requirements of the latest version of ANSI Standard B 19 .3 Safety
Standard for Compressors for Process Industries .
„ Moisture or oil in the air compressor may accelerate wear and corrosion in
the stapler .
„ Drain daily .
Connections
1 .
Fittings
Install a female coupler to the hose . The female coupler will connect to the quick
release that fits the tool .
2 .
Filter-Regulator-Lubricator
„ NEVER connect stapler to pressure which potentially exceeds 150psi .
„ Filter-regulator-lubricator units supply an optimum condition for the stapler
and extend the stapler life . These units should always be used .
Filter
„ The filter removes moisture and dirt mixed in compressed air .
„
Keep the filter clean by maintaining tool regularly .
„ Drain daily .
Regulator
„
The regulator controls the operating pressure for safe operation of the
stapler .
„ Inspect the regulator before operation to be sure it operates properly .
„
Use a regulator with a pressure range of 0-100psi .
Lubricator
„ The lubricator supplies an oil mist to the stapler .
„
Inspect the lubricator before operation to be sure the supply of lubricant is
adequate .