16 Ga. Wide Crown Stapler
Drives 15/16" Crown Staples (5/8" to 2" / 16 to 50mm)
Model No. SGSW5016
Item No. 64415
10
Interchange Brands
Operator’s Manual
OpERATING THE TOOL
METHODS OF OpERATION
Sequential Fire Trigger
To be used in applications where precise fastener
placement is preferred .
This trigger reduces the chances of double firing and
unintentional firing .
1 . With your finger off the trigger, press the safety all the
way down on the surface of the material the fastener is
being driven into .
2 . Pull the trigger firing a fastener into the material .
3 . The tool will not fire again until the trigger is released
and the safety is removed completely from the material
being used .
4 . To fire the next fastener, repeat the above steps .
Caution: do not carry tool with trigger depressed.
This could result in accidental firing of the tool.
2
1
STApLE LOADING
Keep stapler pointed downward .
Pull the staple feeder backward until it latches .
Place the staple strip onto the rail of the magazine . Make
sure that the staple strip slides freely on the magazine .
Do not load with safety or trigger depressed .
Release the feeder from the latch and gently allow it to
move forward .
The stapler is now ready to operate .
CAUTION:
A staple can be driven unintentionally if the trigger and
safety bracket are activated at the same time . Always
disconnect the stapler from the air supply prior to loading
staples, making any adjustments, or performing any
service on the stapler . Remember to keep finger off the
trigger until you are ready to drive a fastener .
Be sure to release the staple feeder, avoiding any impact .
Never connect stapler to pressure that potentially
exceeds 150 psi .
Never use non-relieving coupler on stapler .
Never use oxygen or other bottled gases, as an explosion
may occur .
1
2
