16 Ga. Wide Crown Stapler
Drives 15/16" Crown Staples (5/8" to 2" / 16 to 50mm)
Model No. SGSW5016
Item No. 64415
14
Interchange Brands
Operator’s Manual
OpERATING THE TOOL
TESTING THE STApLER
Before using the stapler, test it by using the check list below . Conduct the test in the following order .
If abnormal tests occur, stop using the stapler and contact an authorized service center immediately .
1.
Disconnect air hose from stapler .
Remove all staples from stapler .
ALL SCREWS MUST BE TIGHTENED.
If any screws are loose, tighten them .
THE SAFETY/pUSH LEVER AND
TRIGGER MUST MOVE SMOOTHLY.
2.
Adjust the air pressure to 70 psi .
Connect the air hose .
Do not load any staples in the
stapler .
THE STApLER MUST NOT LEAK AIR.
Hold the stapler downward and pull
the trigger .
THE STApLER MUST NOT LEAK AIR.
3.
Remove the finger from the trigger
and press the safety/push lever
against the wood .
THE STApLER MUST NOT OpERATE.
4.
Without touching the trigger, depress
the safety/push lever against the
work piece .
Pull the trigger .
THE STApLER MUST OpERATE.
5.
With the stapler off of the work
piece, pull the trigger . Depress the
push lever against the work piece .
THE STApLER MUST OpERATE.
6.
If no abnormal operation is
observed, you may load staples in
the stapler .
Drive staples into a test piece that
is the same type to be used in the
actual application .
THE STApLER MUST OpERATE
pROpERLY.
